Basic CLI Command Reference
94 Basic System Configuration Guide
Context show>router>mpls
Description This command displays MPLS LSP egress statistics information.
lsp-ingress-stats
Syntax lsp-ingress-stats
lsp-ingress-stats ip-address lsp lsp-name
Context show>router>mpls
Description This command displays MPLS LSP ingress statistics information.
management-access-filter
Syntax management-access-filter
Context monitor
Description This command enables the context to monitor management-access filters. These filters are configured
in the config>system>security>mgmt-access-filter context.
ip
Syntax ip entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>management-access-filter
Description This command monitors statistics for the MAF IP filter entry.
Parameters entry entry-id — Specifies an existing IP MAF entry ID.
Values 1 to 9999
interval seconds — Configures the interval for each display in seconds.
Default 10
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
To Next Page
Loading...
