CLI Usage
Basic System Configuration Guide 95
ipv6
Syntax ipv6 entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>management-access-filter
Description This command monitors statistics for the MAF IPv6 filter entry and applies to the 7750 SR and
7950 XRS.
Parameters entry entry-id — Specifies an existing IP MAF entry ID.
Values 1 to 9999
interval seconds — Configures the interval for each display in seconds.
Default 10
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
mac
Syntax mac entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>management-access-filter
Description This command monitors statistics for the MAF MAC filter entry.
Parameters entry entry-id — Specifies an existing IP MAF entry ID.
Values 1 to 9999
interval seconds — Configures the interval for each display in seconds.
Default 10
Values 3 to 60
repeat repeat — Configures how many times the command is repeated.
Default 10
Values 1 to 999
absolute — When the absolute keyword is specified, the raw statistics are displayed, without
processing. No calculations are performed on the delta or rate statistics.
To Next Page
Loading...
