Basic CLI Command Reference
96 Basic System Configuration Guide
rate — When the rate keyword is specified, the rate-per-second for each statistic is displayed
instead of the delta.
port
Syntax port port-id [port-id...(up to 5 max)] [interval seconds] [repeat repeat] [absolute | rate]
[multiclass]
Context monitor
Description This command enables port traffic monitoring. The specified port(s) statistical information displays at
the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified port(s). The subsequent statistical
information listed for each interval is displayed as a delta to the previous display.
When the rate is specified, the "rate per second" for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters port port-id — Specify up to 5 port IDs. Port-IDs are only MLPPP bundles or bundle protection
groups when the multiclass is specified.
Syntax:
port-id slot/mda/port [.channel]
eth-sat-id esat-id/slot/port
esat keyword
id 1 to 20
pxc-id pxc-id.sub-port
pxc keyword
id 1 to 64
sub-port a, b
aps-id aps-group-id[.channel]
aps keyword
group-id 1 to 64 (16 for 7750 SR-c12 and
7750 SR-c4)
bundle ID bundle-type-slot/mda.bundle-num
bundle keyword
type ima, ppp
bundle-num 1 to 128 (16 for 7750 SR-c12
and 7750 SR-c4)
To Next Page
Loading...
