Rockwell Automation Publication 20B-IN026C-EN-P - October 2015 91
Converter Assembly Component Replacement Procedures Chapter 4
Install Components
1. Install the new heatsink fan to the mounting plate. Torque the mounting
screws to 5.6N•m (50lb•in).
2. Install the new gasket (if needed) and mounting plate to the chassis.
Torque the mounting screws to 2.9 N•m (26 lb•in).
3. Connect the wires from TB12 to the Transformer (120, N, PE).
4. Connect the wiring plugs, and reinstall the plastic wire ties.
5. Replace all safety shields and enclosure covers before applying power to the
drive.
To Next Page
Loading...
