ix
f) S
et the MODE keyswitch at “ ” when installing or removing the saw blade,
or lubricating the saw blade tension slides and driven wheel bearing.
g) Never look directly into the
source of the laser beam.
You may lose your eyesight.
h) Never start the saw blade
unless it has been confirmed
that the work is firmly
clamped. If the work cannot
be securely clamped, be sure
to clamp it using jigs. It is
dangerous if the work falls or
rolls during cutting.
i) When cutting a thin piece from
the work, take preventive
measures to keep the cut
piece from falling. It is
dangerous if the cut piece
falls.
Take care also that the cut
piece may fall when the saw
blade guides are operated.
To Next Page
Loading...
