Ametek SEQUOIA Series - Page 194

194 Sequoia Series
Command Syntax IEC413:FCURve:PAUSe <NRf+>
Parameters
Examples IEC413:FCURve:PAUS 2
Query Syntax IEC413:FCURve:PAUS?
Returned Parameters <NR1>
IEC413:OSWing:LEVel
This command will set the level for the ‘over swing’ harmonics combination test. The command has
two parameters, one for the third and one for the fifth order harmonic. The IEC413:STATe must be in
the off position and the user class must be selected to accept the command.
Command Syntax IEC413:OSWing:LEVel <NRf+>,<NRf>
Parameters 0 to 20%
Examples IEC413:OSWing:LEVel 10
Query Syntax IEC413:OSWing:LEVel?
Returned Parameters <NR2>
IEC413:OSWing:DWELl
This command will set the dwell time in seconds for the over swing harmonics combination test. The
class must be selected prior to this command. Query with min and max to find the range of the dwell
time.
Command Syntax IEC413OSWing:DWELl <NRf+>
Parameters
Examples IEC413:OSWing:DWEL 10
Query Syntax IEC413:OSWing:DWEL?
Returned Parameters <NR1>
IEC413:OSWing:PAUSe
This command will set the pause time in seconds. This is the time between tests when RUN:ALL is
selected. The class must be selected prior to this command. Query with min and max to find the
range of the pause time.
Command Syntax IEC413:OSWing:PAUSe <NRf+>
Parameters
Examples IEC413:OSWing:PAUS 2
Query Syntax IEC413:OSWing:PAUS?
Returned Parameters <NR1>