Ametek SEQUOIA Series - Page 34

34 Sequoia Series
:LROFset Calibrate the offset current at the low range
:HROFset Calibrate the offset current at the high range
:VOLTage
[:AC]
[:FSCale] CALibration full-scale AC voltage measurements
:OFFset Calibrate the AC offset voltage.
:DC
[:FSCale] CALibration full-scale DC voltage measurements
:NEGative CALibration full-scale negative DC voltage
measurements
:OFFset Calibrate the DC offset voltage.
EXTernal
[:FSCale] CALibration full-scale External ADC for RPV or EXT
:OFFSet
[:RMS] CALibration Low end signal for External ADC for
RPV or EXT
:DC CALibration offset DC value for External ADC for
RPV or EXT
[:SOURce]
:PHASe CALibration output phase angle relative to external
sync.
:VOLTage
[:AC]
:LRANge
:OFFset Calibrate the AC offset voltage.
:ZERO Trim output voltage offset.
[:HRANge]
[:FSCale] CALibration full-scale output voltage at high voltage
range
:DC
[:HRANge]
[:FSCale] CALibration full-scale output dc voltage at high
voltage range. (positive DC)
:ZERO Trim output dc voltage offset at high voltage range.
:CURRent
[:AC]
[:HRANge]
[:FSCALE] CALibration full-scale output current at high voltage
range
:LRANge
:OFFset Calibrate the AC offset current
:ZERO Trim output ac current offset at low voltage range.
:DC
[:HRANge]
[:FSCale] CALibration full-scale output dc current at high
voltage range. (positive DC)
:ZERO Trim output dc current offset at high voltage
range.
:LAST Set the last calibrated date in the format dd/mm/yy
:NEXT Set the next calibration date in the format dd/mm/yy
:ADC
:VOLTage