94 Sequoia Series
4.21.3 List - Frequency
LIST:FREQuency
This command sets the sequence of frequency list points. The frequency points are given in the
command parameters, which are separated by commas. The order in which the points are entered
determines the sequence in which they are output when a list is triggered.
Command Syntax [SOURce:]LIST:FREQuency[:LEVel]<NRf+>,<NRf+>
Parameters Values limited to the frequency range
Unit HZ (Hertz)
Examples LIST:FREQ 60,65,70
Query Syntax [SOURce:]LIST:FREQ?
Returned Parameters <NR2>
Related Commands LIST:FREQ:POIN? LIST:COUN LIST:DWEL
LIST:STEP LIST:FREQ:SLEW
LIST:FREQuency:POINts?
This query returns the number of points specified in LIST:FREQuency. Note that it returns only the
total number of points, not the point values.
Query Syntax [SOURce:]LIST:FREQ[:LEVel]:POINts?
Returned Parameters <NR1>
Example LIST:FREQ:POIN?
Related Commands LIST:FREQ
LIST:FREQuency:SLEW
This command sets the sequence of frequency slew list points. The frequency points are given in the
command parameters, which are separated by commas.The order in which the points are entered
determines the sequence in which they are output when a list is triggered.
Command Syntax [SOURce:]LIST:FREQuency:SLEW<NRf+>,<NRf+>
Parameters 0.01 to 1E9MAXimum
Unit HZ (Hertz) per second
Examples LIST:FREQ:SLEW 10, 1E2, MAX
Query Syntax [SOURce:]LIST:FREQ:SLEW?
Returned Parameters <NR3>
Related Commands LIST:FREQ:SLEW:POIN? LIST:COUN
LIST:DWEL LIST:STEP LIST:FREQ
LIST:FREQuency:SLEW:POINts?
This query returns the number of points specified in LIST:FREQuency:SLEW. Note that it returns only
the total number of points, not the point values.
Query Syntax [SOURce:]LIST:FREQ:SLEW:POINts?
Returned Parameters <NR1>
Example LIST:FREQ:SLEW:POIN?
Related Commands LIST:FREQ:SLEW
To Next Page
Loading...
Need help?
General
