Sequoia Series 99
LIST:VOLTage:SLEW:POINts?
Phase Selectable
This query returns the number of points specified in LIST:VOLTage:SLEW. Note that it returns only
the total number of points, not the point values.
Query Syntax [SOURce:]LIST:VOLTage:SLEW:POINts?
Returned Parameters <NR1>
Example LIST:VOLT:SLEW:POIN?
Related Commands LIST:VOLT:SLEW
4.21.9 List:Current
LIST:CURRent
Phase Selectable
This command specifies the output current points in a list. The current points are given in the command
parameters, which are separated by commas. The order in which the points are entered determines
the sequence in which the list will be output when a list transient is triggered.
Command Syntax [SOURce:]LIST:CURRent[:LEVel] <NRf+>,<NRf+>
Parameters Value depends on the voltage range and the voltage mode
Unit A (rms)
Examples LIST:CURR 2.0,2.5
Query Syntax [SOURce:]LIST:CURRent[:LEVel]?
Returned Parameters <NR2>
Related Commands LIST:CURR:POIN? LIST:COUN LIST:DWELLIST:STEP
LIST:SHAP
LIST:CURRent:POINts?
Phase Selectable
This query returns the number of points specified in LIST:CURR. Note that it returns only the total
number of points, not the point values.
Query Syntax [SOURce:]LIST:CURRent:POINts?
Returned Parameters <NR1>
Example LIST:CURR:POIN?
Related Commands LIST:CURR
LIST:CURRent:SLEW
Phase Selectable
This command specifies the output offset slew points in a list. The slew points are given in the
command parameters, which are separated by commas. The order in which the points are entered
determines the sequence in which the list will be output when a list transient is triggered. Changing list
data while a subsystem is in list mode generates an implied ABORt.
To Next Page
Loading...
Need help?
General
