98 Sequoia Series
4.21.8 List:Voltage
LIST:VOLTage
Phase Selectable
This command specifies the output voltage points in a list. The voltage points are given in the command
parameters, which are separated by commas. The order in which the points are entered determines
the sequence in which the list will be output when a list transient is triggered.
Command Syntax [SOURce:]LIST:VOLTage[:LEVel] <NRf+>,<NRf+>
Parameters Value depends on the voltage range and the voltage mode
Unit V (rms voltage)
Examples LIST:VOLT 2.0,2.5,3.0
LIST:VOLT MAX,2.5,MIN
Query Syntax [SOURce:]LIST:VOLTage[:LEVel]?
Returned Parameters <NR2>
Related Commands LIST:VOLT:POIN? LIST:COUN LIST:DWELLIST:STEP
LIST:SHAP LIST:VOLT:OFFS
LIST:VOLTage:POINts?
Phase Selectable
This query returns the number of points specified in LIST:VOLT. Note that it returns only the total
number of points, not the point values.
Query Syntax [SOURce:]LIST:VOLTage:POINts?
Returned Parameters <NR1>
Example LIST:VOLT:POIN?
Related Commands LIST:VOLT
LIST:VOLTage:SLEW
Phase Selectable
This command specifies the output offset slew points in a list. The slew points are given in the
command parameters, which are separated by commas. The order in which the points are entered
determines the sequence in which the list will be output when a list transient is triggered. Changing list
data while a subsystem is in list mode generates an implied ABORt.
Command Syntax [SOURce:]LIST:VOLTage:SLEW <NRf+>,<NRf+>
Parameters 0.1 to 1E9 | MAX
Unit V/S (volts per second)
Example LIST:VOLT:SLEW 10, 1E2, MAX
Query Syntax [SOURce:]LIST:VOLTage:SLEW?
Returned Parameters <NR2>
Related Commands LIST:VOLT:SLEW:POIN? LIST:COUN
LIST:DWEL LIST:STEP
To Next Page
Loading...
Need help?
General
