Sequoia Series 97
4.21.7 List:TTL Trigger Out
LIST:TTLTrg
This command sets the sequence of Trigger Out list points. Each point which is set ON will cause a
pulse to be output at Trigger Out (Function strobe signal on the system interface) when that list step
is reached. Those entries which are set OFF will not generate Trigger Out pulses. The order in which
the list points are given determines the sequence in which Trigger Out pulses will be output when a
list transient is triggered.
Command Syntax [SOURce:]LIST:TTLTrg<bool> ,<bool>
Parameters 0|1|OFF|ON
Examples LIST:TTLT 1,0,1 LIST:TTLT ON,OFF,ON
Query Syntax LIST:TTLT?
Returned Parameters 0 | 1
Related Commands LIST:TTLT:POIN? LIST:COUN LIST:DWEL
LIST:STEP OUTP:TTLT:STAT OUTP:TTLT:SOUR
LIST:TTLTrg:POINts?
This query returns the number of points specified in LIST:TTLT. Note that it returns only the total
number of points, not the point values.
Query Syntax [SOURce:]LIST:TTLTrg:POINts?
Returned Parameters <NR1>
Example LIST:TTLT:POIN?
Related Commands LIST:TTLT
To Next Page
Loading...
Need help?
General
