AMI 1700 - Commands for Calibrating Level Sensors

74 Rev. 2
Remote Interface Reference
Command Set Reference : Calibration Functions
5.5.6 Commands for calibrating level sensors
Command: MINCAL
Function: Performs a minimum calibration point calibration.
Returns: <CR><LF>
Default: N/A
Command: MAXCAL
Function: Performs a maximum calibration point calibration.
Returns: <CR><LF>
Default: N/A
Command: CONFigure:N2:LENGTH=<value>
Function: Configures the liquid nitrogen sensor active length in current units.
Returns: <CR><LF>
Default: N/A
Note: Returns -5 if the current units are percent.
Command: LENGTH=<value>
Function: Configures the liquid nitrogen liquid level sensor active length in
current units.
Returns: <CR><LF>
Default: N/A
Command: NOSENSCAL
Function: Calibrates the loss of sensor point for the LN
2
measurement function.
Returns: <CR><LF>
Default: N/A