AMI 1700 - Appendix: Troubleshooting and Licenses; Troubleshooting Assistance

68 Rev. 2
Remote Interface Reference
Command Set Reference : Setting Measurement Units
5.5.2 Commands for setting the units of measurement
Command:
CM
Function: Sets the liquid level units of measurement to centimeters.
Returns: <CR><LF>
Default: N/A
Command:
INCH
Function: Sets the liquid level units of measurement to inches.
Returns: <CR><LF>
Default: N/A
Command:
PERCENT
Function: Sets the liquid level units of measurement to percent of active
sensor length.
Returns: <CR><LF>
Default: N/A
Command:
CONFigure:N2:UNIT <value>
Function: Sets the liquid nitrogen level units of measurement to percent
(
0, or PERCENT), centimeters (1, or CM), or inches (2, or INCH)
Returns: <CR><LF>
Default: N/A