AMI 1700 - Error Codes

76 Rev. 2
Remote Interface Reference
Command Set Reference : Calibration Functions
<second> Range is 0 to 60.
The query response message shall consist of three fields
separated by commas: <hour>,<minute>,<second>
Returns: <CR><LF>
Default: N/A
Command: SYStem:TIME?
Function: This command reads the instrument’s clock.
Returns: <hour>,<minute>,<second><CR><LF>
Default: N/A
Command: SYStem:REBOOT
Function: This command reboots the instrument.
Returns: <CR><LF>
Default: N/A
Command: SYStem:RESTORE
Function: This command reboots the instrument and sets all
parameters back to factory defaults.
Returns: <CR><LF>
Default: N/A
5.6 Error Codes
The Model 1700 returns specific error codes for invalid commands and/or
arguments. If an error condition is returned, the command is not processed
and the configuration of the instrument is not modified. The table below
provides a list of error codes, their meaning, and any associated limits.
Error
Code Meaning Valid Range
-1
LO (or relay №2
a
) setpoint out of
range
0
LO (or relay №2
a
) LENGTH
-2
Fill B setpoint (fill start) out of range
0
 B < A
-3
Fill A setpoint (fill stop) out of range
B < A
 LENGTH
-4
HI (or relay №1
a
) setpoint out of range 0  HI (or relay №1
a
)  LENGTH
-5
Attempted to set or query for LENGTH
in PERCENT units mode