Enova DGX WebConsole Interface
151
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
Enova DGX WebConsole Interface
“05002 - Enova DGX [8, 16, 32, 64]” Overview
The WebConsole includes pages specifically for the Enova DGX Switcher. When it is selected in the Device
drop-down list in the upper right of the WebConsole’s Master Configuration Manager (FIG. 87), the pages provide an
interface for certain system attributes that the integrated Master monitors and controls.
Note: The default Device Number for the Enova DGX Switcher is 5002.
This chapter uses examples that assume an Enova DGX 16 is connected to a LAN via its ICS 100/1000 port
(see page 52) and that the WebConsole has been accessed (see page 55).
Important: For information on using the WebConsole for Master functions, refer to the “WebConsole &
Programming Guide – NetLinx Integrated Controllers” (available at www.amx.com
).
icsp Device Config - Enova DGX 16 Device Config
The icsp Device Config tab opens to the Enova DGX 8/16/32/64 Device Config page (Enova DGX 16 shown in
FIG. 87). On the left of the page is a field for editing the device number for the Enova DGX 8/16/32/64. On the right
under Current Application Information, the version for the interface is displayed.
Important: You must
be logged in to a device to change its device number.
The three tabs available on the icsp Device Config page are:
icsp Device Config
Upgrade
IP Control
FIG. 87 icsp Device Config tab/page – Enova DGX 16 Device Config
Select the Enova DGX 8/16/32/64 to access
the icsp Device Config tab/page.
To Next Page
Loading...
Need help?
General
