EasyManuals Logo

AMX Enova DGX 8 User Manual

AMX Enova DGX 8
243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #236 background imageLoading...
Page #236 background image
Appendix H – DGX_SHELL Commands
236
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
Basic DGX_SHELL Commands
The DGX_SHELL commands listed in the table below can be sent directly to the Enova DGX Switcher via any standard
emulation terminal once you enter the DGX_SHELL.
Note: BCPU is the acronym for Board CPU, and AIE is the acronym for Audio Insert/Extract (board).
At the DGX_SHELL prompt, type help or a question mark (?) and press Enter to access the Help Menu, which
displays all of the DGX_SHELL commands, including the basic ones described in the table below.
Basic DGX_SHELL Commands
Command Description
?
help
Either of these commands displays all of the supported commands: those listed in this table, plus
advanced commands for troubleshooting (for technical support; see page 69).
help -a
help -v
The help -a command displays a list of all available commands
The help -v (verbose) command lists the commands and their descriptions.
Usage: help {-a}{-v}
Note: -a and -v can also be used with the ?.
help <cmd>
? <cmd>
Either of these commands displays detailed usage and options for the command specified.
Usage: help {<command>} or ? {<command>}
announce This command sends a network message via a proprietary protocol. Devices on the network that
understand the protocol (e.g., HDMI and DXLink Input and Output Boards) respond with identifying
information (e.g., IP address) which then gets printed in the shell.
bcs This command is used to exit the DGX_SHELL and launch the standard terminal interface where BCS
commands can be entered. (No re-logging is required once you leave the DGX_SHELL session.)
Usage: bcs {<bcs_syntax_cmd>}
<bcs_syntax_cmd> = bcs syntax command string
bcs with a command argument will execute and then return to the shell.
bcs without a command argument will remain in the BCS Interpreter until exited with a CTRL+C.

Table of Contents

Other manuals for AMX Enova DGX 8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the AMX Enova DGX 8 and is the answer not in the manual?

AMX Enova DGX 8 Specifications

General IconGeneral
BrandAMX
ModelEnova DGX 8
CategorySwitch
LanguageEnglish

Related product manuals