AMX Enova DGX 8 User Manual

Firmware Upgrade & Info for Network Admin
163
Instruction Manual – Enova DGX 8/16/32/64 Digital Media Switchers
Changing the Proxy Setting
If the WebConsole does not open during setup, try the following troubleshooting strategies:
Check all power, signal, and link connections on all of the equipment.
Check LED indicators for the TCP/IP (RJ-45) connector on the Enova DGX enclosure.
If the LED indicators are not illuminated, check the cable type to make sure it meets cable requirements (see
page 47).
Ping the system, i.e., at the DOS prompt enter: ping XXX.XXX.XXX.XXX
(where XXX.XXX.XXX.XXX is the NXB-AP-1000 Interface IP address; see page 52).
Try connecting to the WebConsole again.
If the WebConsole still does not open, you may need to add an exception in the Proxy Setting dialog box.
The following instructions apply to Internet Explorer. To change these settings in another browser, consult its Help file.
To add an exception to the proxy setting information:
1.
From the Tools menu on the browser, select Internet Options.
The Internet Options dialog box opens.

AMX Enova DGX 8 Specifications

General

Brand	AMX
Model	Enova DGX 8
Category	Switch
Language	English