ReceiverReceiver
Receiver gainReceiver gain
TransceiverTransceiver
55..11..22 Receiver SetupReceiver Setup
55..11..22..11 Physical SetupPhysical Setup
When the receiver is set up with an SDH interface, touching the RxRx button in
the navigation area will launch the following screen. (Note that the SDH RxSDH Rx
check box above the connector panel illustration is selected.)
This screen allows you to make the physical setup of the receiver in SDH
mode. It can also be used to confirm the current status of the selected port.
The configuration options available in the setup area of the screen are
described below. The status information is described in a separate section.
Touch the button corresponding to the relevant interface type.
OffOff: No interface
SFP/SFP+SFP/SFP+: Optical interface
ElectricalElectrical: Electrical interface (BNC connector)
Only relevant for electrical receivers. Select the attenuation and impedance
mode from the drop-down menu.
TerminateTerminate: Up to 12 dB cable attenuation, nominal impedance
MonitorMonitor: 20 dB linear attenuation and up to 12 dB cable attenuation, nominal
impedance.
Displays the Transceiver information when Optical Transmitter is selected.
To Next Page
Loading...
