Alarms/Errors/Alarms/Errors/
OthersOthers
Emphasis is applied to the bit immediately before where the data changes.
Post
Emphasis is applied to the bit where data changes.
RxRx
Allows to set the gain of the high frequency band for the reception circuit in
Network Master.
Rx Equalizer
Equalization can be set. Rx EqualizerRx Equalizer is displayed when the transceiver is
SFP28.
DFE
The mode of boost can be set.
Insertion loss
The gain of the Rx circuit is up to 8 dB in 2 dB steps.
0: 0 dB
1: 2 dB
2: 4 dB
3: 6 dB
4: 8 dB
PrecodingPrecoding
PrecodingPrecoding is displayed for only BERT application when the transceiver is
QSFP-DD.
66..11..44 Errors/Alarms InsertionErrors/Alarms Insertion
This section describes the errors or alarms insertion for the Ethernet layer on
the Application toolbar.
Select the port to insert errors, and the stimuli type. The settings items vary
depending on the selected stimulus type.
Ethernet LANEthernet LAN: Inserts errors or alarms related the Ethernet frame, IP packet
or the pattern error.
Ethernet PCS alarms/errorsEthernet PCS alarms/errors: Inserts errors or alarms to PCS blocks.
Ethernet PCS skewEthernet PCS skew: Inserts skew between specified lanes.
To Next Page
Loading...
