SettingsSettings
Touching the InitializeInitialize button initializes register values in the transceiver.
Read/WriteRead/Write
Specifying the address and the page allows users to read or write the data.
Burst ReadBurst Read
Specifying the top address, page, and length allows users to read the data.
Touching the ExportExport opens the dialog box to save the read data.
Touching the SettingsSettings button at right hand bottom displays the dialog box. The
contents of the dialog box varies depending on the transceiver module.
This dialog box allows to set Network Master interface to the optical
transceiver. TxTx table allows users to set the emphasis coefficients for Tx Output
signal in the figure below. Rx EqualizerRx Equalizer table allows users to set the
equalization values for Rx Input signal in the figure below.
When setting same value at all lanes, touch the button in TrackingTracking column and
set the button display to OnOn. The value set at Lane 0 is applied to all lanes.
When setting a different value at each lane, touch the button in TrackingTracking
column and set the button display to OffOff. Set the value by touching the field for
each lane.
TxTx
Allows to set the output waveform of Network Master.
VOD
VOD (Voltage Output Differential) can be set.
Pre
To Next Page
Loading...
