22..77 How to Attach the ModulesHow to Attach the Modules
This section explains how to install the modules using the MT1000A,
MU100010A 10G multirate module, and MU100090A High Performance GPS
Disciplined Oscillator as examples. The procedure of installing the modules is
the same for MT1040A.
MU100090A is attached to the Network Master with one of the following
modules.
MU100010A
MU100011A
MU104011A
MU104014A
MU104015A
CATIONCATION
Replacing modules operation should be done on the table where antistatic
measures are taken.
Do not drop the modules or give a shock.
Doing so may cause the failure.
22..77..11 Replacing the MU100010A 10G Multirate moduleReplacing the MU100010A 10G Multirate module
1. Switch the Network Master OFFOFF.
2. Before the detaching operation, disconnect the AC adapter and remove the
battery pack.
3. Place the Network Master on its front on a plain surface.
4. Loosen the screws (shown by the yellow circle) on rear side of the MU100010A
10G Multirate module.
To Next Page
Loading...
