1. Connect an Ethernet network cable to the LAN connector on your Network
Master and link this to a Local Area Network.
2. Assign an IP address to the Network Master. This is done in the
Ethernet
setting available from the Network screen as described in the
Graphical User
Interface
chapter.
3. Enable Allow remote PCAllow remote PC in the Remote Control.
4. Display the Resource Monitor. Confirm that the IP address and "running Tests
and Views" appear.
5. Change the Network settings of the PC, so it can access the Network Master
via Ethernet.
Select Control Panel -> Network and Internet -> Network Connection.
Right-click the interface and click the Properties.
Select the properties of Internet Protocol Version 4 (TCP/IPv4) and click the
Properties button.
6. Execute Ping command on PC to confirm connection to the Network Master.
33..44..33 Communication PortsCommunication Ports
When using the Control Software with a Network Master connected behind a
port restrictive firewall, to successfully communicate with the instrument, it is
important to configure the firewall to allow communication on the following
ports:
To Next Page
Loading...
