FollowsFollows
To make the currently selected receiver follow either the transmitter or Port 1
receiver (i.e. copy its settings), touch the drop-down menu in the navigation
area and select the relevant value. The receiver settings continue to follow the
change of either the transmitter or Port 1 receiver. The default setting is NoneNone.
Note that the Port 1 receiver cannot follow the Port 2 receiver.
PCM framePCM frame
Use the PCM framePCM frame radio buttons to enable (OnOn) or disable (OffOff) the status of
the PCM frame.
Frame typeFrame type
Use the Frame typeFrame type radio buttons to specify either an M13M13 frame or a C-BitC-Bit
frame.
Pattern typePattern type
Select the requested pattern. Available patterns are the same as the transmitter
setup. Refer to Pattern type in "E1 Setup and Status".
Touch 'Normal' or 'Inverse' pattern type.
Touching the 'ANSI standard' button will apply ANSI/IEEE 1007
recommended Pattern typePattern type for 45 Mbit data rates (PRBS 23 Inverse).
User patternUser pattern
User pattern field is enabled if Pattern type is set to User [32] bitUser [32] bit or User [2084]User [2084]
bitbit. Touch the User patternUser pattern field and use the launched Pattern EditorPattern Editor dialog box
to define the user pattern. Depending on the selected pattern type, different
user pattern setup options will be available.
The length can be any length from 1 bit to 32 bits or from 1 bit to 2048 bits.
55..66..33 Status InformationStatus Information
This section describes the status information available for the DS3 layer in the
status area of the Ports SetupPorts Setup screen.
55..66..33..11 Status SummaryStatus Summary
To Next Page
Loading...
