InitializeInitialize
Touching InitializeInitialize button starts the transceiver initialization.
Pin ControlPin Control
Sets the signal levels to be provided to the control pins of the transceiver.
Vcc: Turns the transceiver power on or off. Set this item OnOn in the regular use.
ResetL: Sets ResetL pin level. Setting this button to LowLow resets the transceiver.
Set this item HighHigh in the regular use.
InitMode: Sets LPMode pin level. When it is set to LowLow the transceiver turns
into Low power mode. Set this item HighHigh in the regular use.
ModSelL: Sets ModSelL pin level. Setting this button to LowLow allows users to
read and write the registers of the transceiver.
StatusStatus
The I
2
C interface status is displayed.
EqualizerEqualizer
Tx Input and Rx Output are electrical interface of the transceiver side as shown
in the figure below. Sets the equalizer values for these signals to the transceiver.
Use Application default settingsUse Application default settings
When the check box is selected, the values defined by the transceiver vendor
are used for the equalizer and you cannot change these values.
ImportImport
Opens the dialog box to lord the equalizer setting values form a CSV file.
ExportExport
Opens the dialog box to saves the equalizer setting values to a CSV file.
Read settingsRead settings
Touching the button reads the equalizer values set in the hardware.
ApplyApply
Touching the button applies the edited equalizer values to the hardware.
Read / WriteRead / Write
Read/WriteRead/Write allows you to read or write values to the specified registers.
Setup ModuleSetup Module
To Next Page
Loading...
