Alarm/Error StatusAlarm/Error Status
Capture/MonitorCapture/Monitor
StatusStatus
The middle part of the status area gives you access to alarm and error
information for the selected interface. The status is indicated by the lamp color.
A summary consisting of the most relevant alarm/error indications is displayed
constantly. By touching the summary, you can launch a display that contains
all alarms/errors.
At the bottom of the status area are below buttons that give you access to
various capture/monitor information. By touching a button, you can launch the
corresponding information display.
OH captureOH capture
Tributary scanTributary scan
TransceiverTransceiver
55..22..33..22 Physical DetailsPhysical Details
Refer to Physical Details in "SDH Setup and Status".
55..22..33..33 Alarms and ErrorsAlarms and Errors
Touching the middle summary box in the status area of the Ports SetupPorts Setup screen
allows you to launch the dialog box shown below.
This dialog box contains detailed alarm and error information related to the
SONET interface. Status is indicated by the use of colored Lamp icons.
Alarms
LOSLOS: Loss of Signal
LOFLOF: Loss of Frame
OOFOOF: Out of Frame
AIS-LAIS-L: Line Alarm Indication Signal
RDI-LRDI-L: Line Remote Defect Indication
AIS-PAIS-P: Path Alarm Indication Signal
LOP-PLOP-P: Path Loss of pointer
TIM-PTIM-P: Path Trace Identifier Mismatch
PLM-PPLM-P: Path Payload Mismatch
UNIQ-PUNIQ-P: Path UNEQuipped
To Next Page
Loading...
