CW: Codewords)
PCS/FEC
200G/400G
Alignment marker
LOAML, Marker map, Corr.CW, Uncorr. CW, Corr.
Codeword distribution, Symbol error, Symbol errors rate,
Max symbol errors rate, High SER
Lane skew
Relative skew
LFS local fault, LFS remote fault, 64B/66B code violation,
FEC Degraded SER, Local Degrade, Remote Degrade
Conditions Timestamp source
GPS
*: Frequency results appear only when no OTN layer.
For the parameters of the following WAN performance measurements, refer to
"SDH/SONET Performance Measurement Items" in SDH/SONET/PDH/DSn
Applications.
Note that the same results are displayed because Pass/Fail judgement is not
performed.
SPE stands for Synchronous Payload Envelope.
WAN G.826
WAN G.826+G.829
WAN M.2101.1(M.2100)
M.2100 Performance Measurement ItemsM.2100 Performance Measurement Items
This paragraph describes the performance result items. Measurement time
definitions are as below.
S
Total
Total measurement time. This is the total time of the measurement excluding
the time of power failure.
S
Avail
Available time of measurement. Calculated from the following formula:
S
Avail
=S
Total
-S
Unavail
S
Unavail
Unavailable time of measurement. Refer to UAT definition.
To Next Page
Loading...
