Burst modeBurst mode
DutyDuty
Frame sizeFrame size
Measurement SetupMeasurement Setup
Set the burst generation mode. The normal Ethernet frames are not sent in the
burst mode.
OffOff: stops sending the stream.
ConstConst: generates the bursts that the data length and the gap length are
constant.
When ConstConst is selected, "Burst" is displayed on multi stream slide.
Number of BurstsNumber of Bursts
Selecting n-Burstn-Burst allows to set the number of the bursts to generate. If sending
specified number bursts has finished, sending stream will stop.
Set the burst data length and the gap length.
Touch the field of DutyDuty and PeriodPeriod to set the value.
Set the frame size used for the burst data length calculation. 20 bytes
(preamble and IFG) adding to the value set in this field is used as the one
frame size of the burst data length.
66..55..22..44 Streams - Meas.Streams - Meas.
Touching the Streams - Meas.Streams - Meas. button in the navigation area displays the
following screen.
The FollowFollow button appears when the Port 2 settings can follow Port 1.
This screen allows you to configure Frame LossFrame Loss, JitterJitter, and LatencyLatency.
Frame lossFrame loss
Select the check box to measure Frame Loss.
When selecting ThresholdThreshold check box and enter the value, Pass/Fail is judged.
If selecting CountCount, set the frame loss number.
To Next Page
Loading...
