The EBS test can only be executed if EIR is greater than zero. If CIR is greater than zero,
the EBS test also requires that CBS is greater than zero. Furthermore, it must be possible
to send at least twice the number of EBS bytes with EIR rate within the step duration.
Service Acceptance Criteria tabService Acceptance Criteria tab
The Service Acceptance CriteriaService Acceptance Criteria tab contains the following parameters:
Traffic policing marginTraffic policing margin
Only active when the traffic policing test is enabled. Allows you to specify a
margin for the pass/fail evaluation during the service configuration test. The
test will fail if the throughput is greater than CIR + EIR + Margin.
Frame transfer delay / RT Frame transfer delayFrame transfer delay / RT Frame transfer delay
Allows you to specify the maximum acceptable transfer delay in ms (mean).
Frame delay variation / RT Frame delay variationFrame delay variation / RT Frame delay variation
Allows you to specify the maximum acceptable frame transfer deviation in ms
(mean).
Frame loss rateFrame loss rate
Allows you to specify the maximum acceptable frame loss rate.
AVAILAVAIL
Allows you to specify the minimum acceptable availability percentage.
Color Aware tabColor Aware tab
The Color AwareColor Aware tab contains the following parameters:
To Next Page
Loading...
