44
To set up a search group, press the [F] key, then press the [SRCH] key.
8-2-1 BANK LINK SETTING
1. There are 10 search groups and the group number can be selected between 0 ~ 9.
Rotate the dial knob to select the search group. Then press the [▼] key to go to bank select menu.
You can also use the numeric keypad to select the search group.
To return to Search group selection menu, press the [▲] key.
2. Rotate the dial knob to select the bank link group. Pressing the [PASS] key will toggle the link ON and
OFF.
3. Press the [ENT] key to complete setting or press the [CLR] key to abort entry.
8-2-2 SEARCH DELAY
The search delay parameter affects the time the AR-DV1 will remain on an active channel in the search
mode once the received signal has disappeared and the squelch is closed. This is particularly useful
for customizing how long the receiver will wait for a reply before continuing to search.
The parameter ranges are off, hold and 0.1 to 9.9 seconds in 0.1 second increments.
(Default: 2.0 seconds)
To set the search delay parameter, perform the following steps:
1. On the search group setting screen, use the [▼] key or [▲] key to select [DELAY].
2. Rotate the dial knob to select the search delay.
3. If “HOLD” is selected, the receiver will stop searching
4. To confirm entry, press the [ENT] key. To set other parameters, press the [▼] key.
8-2-3 SEARCH PAUSE
The search pause parameter determines how long the receiver will remain on an active frequency before
resuming searching even if the channel is still busy. Search pause helps keep you from having to
manually intervene to force the search to continue or use channel lockout (pass).
The parameter ranges are off and 1 to 60 seconds. When the parameter is set to off, the receiver
remains on the busy frequency until the received signal disappears or the search frequency is changed.
To set the search pause parameter, perform the following steps:
1. On the search group setting screen, use the [▼] key or [▲] key to select [FREE].
2. Rotate the dial knob to set search pause parameter (between 1 ~ 60 or off). To set search pause to
off (zero), press the [PASS] key or enter “0” from the numeric keypad.
3. To confirm entry, press the [ENT] key.
To Next Page
Loading...
