47
Press the [ENT] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or press the [▼] key to move to the next item on the configuration menu.
9-4 CONFIGURE DIMMER
The AR-DV1 is equipped with high intensity LEDs to illuminate the LCD when operating in areas of low
level lighting.
The dimmer function adjusts the brightness of the backlit lamp and may be configured in two ways:
OFF This is default setting. The lamp will illuminate normally.
ON The brightness of the display may be decreased by approximately 50%. However, the brightness
of the keypad will not be changed.
To access the configuration menu, press the [F] key and then the [7] key.
Press the [▼] key to select “DIMMER” parameter in reverse contrast. Rotate the dial knob to select the
desired setting.
Press the [ENT] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or, press the [▼] key to move to the next item on the configuration menu.
9-5 CONFIGURE KEYCOLOR
The AR-DV1 is equipped with high intensity LEDs to illuminate the keypad.
The color of the keypad may be configured in eight ways:
OFF (default) The keypad will not be illuminated all the time.
The color of the backlit keypad can be selected from the following: BLUE, RED, MAGENTA,
GREEN, CYAN, YELLOW, ORANGE
To access the configuration menu, press the [F] key, and then press the [7] key.
Press the [▼] key to select “KEYCOLOR” parameter in reverse contrast. Rotate the dial knob to select the
desired setting.
Press the [ENT] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or, press the [▼] key to move to the next item on the configuration menu.
To Next Page
Loading...
