48
9-6 CONFIGURE SQL.SKIP
The squelch skip menu is used to configure the SD card voice recording when squelch is open or closed.
When squelch skip is set to OFF, the recording process will take place even when the squelch is closed
and no audio signal is present.
When squelch skip is set to ON, the recording process will take place only when the squelch is opened
and an audio signal is present. This is the default setting.
To access the configuration menu, press the [F] key and then the [7] key.
Press the [▼] key to select “SQL.SKIP” parameter in reverse contrast.
Rotate the dial knob to select the desired setting.
Press the [ENT] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or, press the [▼] key to move to the next item on the configuration menu.
9-7 CONFIGURE ID
It is possible to change the receiver’s Identification address when multiple units are connected to the same
port.
It is possible to connect up to 99 units at once while each receiver is assigned a different address.
The value is adjustable between 00 ~ 99. The default setting is 00.
To access the configuration menu, press the [F] key and then the [7] key.
Press the [▼] key to select “ID” parameter in reverse contrast. Rotate the dial knob to select the desired
setting between the range of 00 ~ 99.
Press the [ENT] key to accept the entry and return to a standard display.
Alternatively, press the [CLR] key to abort entry.
Or, press the [▼] key to move to the next item on the configuration menu.
9-8 CONFIGURE REMOTE.BPS (BAUD RATE)
The Remote BPS Set menu is used to configure the communication port control settings as it is
important that they exactly match those of an associated computer connection.
To access the configuration menu, press the [F] key and then the [7] key.
To Next Page
Loading...
