SW Version 2.04 30-January-2009 Page 15 of 128
The secure login supports one pre-defined user account, the admin user. This
password protects the WEB GUI only, i.e the SOAP interface is not password
protected.
User Admin
Default password admin
To change the password press the change button. The following dialog appears
Type in the password and press Set. Then press close to exit the dialog.
4.1.5 Optional Languages
It is possible to specify one or two default languages which will always be available
when configuring a decoder module. Since the drop-down list of available languages
only includes the languages currently present in the transport stream, this enables the
operator to select languages expected to be present in the transport stream at a later
point in time.
Open the Admin folder in the navigation pane and select the module hosting the
management interface (MMI).
Figure 8 - Optional Languages
Enter up to two additional languages in the Optional Languages box. Language
codes should be separated by a comma, e.g. <nor,dan>.
To Next Page
Loading...