SW Version 2.04 30-January-2009 Page 24 of 128
Figure 13. DVB-S2 input
The DVB-S2 input window shows all the major configuration settings as well as the
current bit rate and service information. The following parameters are available:
Port Shows the port on the DVBS2 input module
Rate[Mbps] Shows the incoming data rate
CC Err Bit Error Rate is a quality indication of the input signal. Incorrect
configuration of the transponder parameters will display no sync.
Service Filtering of the displayed service information. When selected, only the
services available from the selected input port are displayed under
Services.
PID Packet Identifier. When selected, all available PIDs from the
selected input port are displayed instead of the service list.
Mode Switch between DVB and MPEG mode. Default is DVB. Please use the
MPEG mode if the incoming transport stream is not DVB compliant.
SATF[GHz] Satellite Frequency. The satellite transponder frequency.
LNBF[GHz] Low Noise Block Frequency.
SRate Symbol Rate. The symbol rate of the incoming DVBS2 signal. The
valid range is 1
Modulation DVB, DVBS2_QPSK, DVBS2_8PSK
ICode Inner Code. The FEC overhead fraction. E.g. ¾. Auto mode
automatically detects the FEC used.
LNBV Low Noise Block Voltage. 0V, 13V or 18V.
22 kHz On/Off
Enable Enable the corresponding input port
The configuration of the above listed parameters is accessible via the edit link to the
right of each input. Pressing this link produces the following dialog.
To Next Page
Loading...