ASE2000 V2 Communication Test Set User Manual 106
Rear View
WHEN CONNECTING THE POWER CABLE BETWEEN THE BCOM-USB DEVICE
AND 2-CHANNEL ASE BELL-202 TEST SET MODEM, THE USB CABLE BETWEEN
THE PC AND BCOM-USB DEVICE MUST BE DISCONNECTED.
CONNECT ALL POWER AND RS-232 CABLES BEFORE CONNECTING THE BCOM-USB
DEVICE TO THE PC.
The bottom of each BCOM-USB device contains a serial number which is used for device
registration and BCOM-USB license management. For certain support and upgrade situations,
you may be asked to provide this serial number.
Bottom View
To Next Page
Loading...