Applied Systems Engineering ASE2000

ASE2000 V2 Communication Test Set User Manual 18
4.4.2. TaskModeDeviceSelectionandConguration
In Task Mode, protocol selection and conguration is accomplished by selecting a device where
protocol is a property of the device selected. Device selection is performed in one of three ways:
• Default device on start-up – If the default Operational Mode on start-up is Task Mode and
there was an “active” device during the previous execution, the last active device will be the
default active device on start-up.
• Selectpreviouslydeneddevice – To select a device that is di󰀨erent than the current active
device, select from the list of displayed devices in the “Task” window. If the required device
has been previously dened but does not appear in the list of displayed devices, select “Edit
> Congure RTUs…” and check the “Display” check box for the desired device then select
“Finish”. The device should now be displayed in the devices area of the Task window and can
be selected as the active device by clicking on the line containing the device.