APRILIA RSV4 Factory a-PRC 2009 User Manual

If deformations or broken material are found on the
sliding surface, replace the freewheel gear (2).
Check the freewheel sliding surface (2) for wear.
Make sure that the woodruff key slot is in perfect
condition.
Remove the needle cage (3) and the roller cage (4) from their housings on the freewheel (2) and check
the rollers/needles for wear.
Check for wear on the freewheel sliding surface (2).
Fitting the idle gear
NOTE
BE CAREFUL IN MAINTAINING THE CORRECT GEAR RATIO, FOLLOWING THAT INDICATED IN
THE TABLE.
MOTOR AND GEAR
Model
Engine No. Starter motor Transmission Freewheel gear
MY 2009/2010 - "V4"
marking
From the beginning of
production at No. 7419
Denso Z=12/64 Z=49
MY 2010 - "V4" marking From No. 7420 to No.
8922
Mitsuba Z=12/64 Z=49
MY 2011 - "V4-A" mark-
ing
From the beginning of
production at No. 1003
Mitsuba Z=12/64 Z=49
MY 2011 - "V4-A" mark-
ing
From No. 1004 onwards Denso Z=12/64 Z=49
Engine RSV4 Factory a-PRC
ENG - 284

APRILIA RSV4 Factory a-PRC 2009 Specifications

General

Brand	APRILIA
Model	RSV4 Factory a-PRC 2009
Category	Motorcycle
Language	English