APRILIA RSV4 Factory a-PRC 2009 User Manual

•
Warm up the engine up by running it for
a few minutes, then switch it off. After
thirty seconds, check the level in the
sight glass. Top up if necessary.
CAUTION
NEVER ALLOW THE OIL LEVEL TO DROP BELOW THE
MINIMUM LEVEL OR FILL ABOVE THE MAXIMUM LEVEL;
IF YOU DO NOT COMPLY WITH THE MINIMUM AND MAX-
IMUM OIL LEVELS THE ENGINE COULD BE SERIOUSLY
DAMAGED
Engine oil filter
Replace the engine oil filter each time you
change the engine oil.
•
Drain the engine oil completely.
•
Unscrew and remove the engine oil fil-
ter from its seat.
NOTE
NEVER REUSE AN OLD FILTER.
•
Spread a thin layer of oil on the sealing ring of the new engine oil filter.
•
Insert and screw the new engine oil filter in the seat, filling the filter to 1/3 of its capacity with
engine oil before fitting.
See also
Replacement
Air filter
•
Remove the fuel tank.
•
Unscrew and remove the eight air filter
box cover screws
RSV4 Factory a-PRC Maintenance
MAIN - 65

APRILIA RSV4 Factory a-PRC 2009 Specifications

General

Brand	APRILIA
Model	RSV4 Factory a-PRC 2009
Category	Motorcycle
Language	English