APRILIA RSV4 Factory a-PRC 2009 User Manual

•
Remove the wheel axle fixing nut.
•
Retrieve the sealing washer.
•
Loosen the screws on the wheel axle
clamps.
•
Tap the wheel axle slightly with a rub-
ber mallet so that the hole on the op-
posite side is exposed.
•
Remove the wheel axle by inserting a
screwdriver in the holes on the pin.
•
During extraction, support the wheel and then remove it.
Checking the front wheel
FRONT WHEEL BEARINGS
Carry out the check with the bearings fitted on the wheel.
CHECK THAT ALL PARTS ARE IN GOOD CONDITION, ESPECIALLY THOSE LISTED AS FOL-
LOWS.
ROTATION CHECK
•
Manually rotate the inside ring of each bearing. Rotation must be constant, smooth and
noiseless.
If one or both bearings do not fall within the control parameters:
Suspensions RSV4 Factory a-PRC
SUSP - 400

APRILIA RSV4 Factory a-PRC 2009 Specifications

General

Brand	APRILIA
Model	RSV4 Factory a-PRC 2009
Category	Motorcycle
Language	English