Receiver Commands 91
Receiver Commands
Dilution of
Precision (DOP)
$PASHS,HDP Set HDOP mask for position
computation
4118
$PASHS,PDP Set PDOP mask for position
computation
40 137
$PASHS,VDP Set VDOP mask for position
computation
4180
Ionospheric and
Tropospheric
Modelling
$PASHQ,ION Query ionospheric measurements Y 126
Memory, Power,
and Diagnostics
$PASHQ,BIT Query Operational Diagnostics — 99
$PASHQ,HST Query Start-up Diagnostics Results — 122
$PASHS,INI Clear internal and BBU memory — 124
$PASHS,POW Set the battery power capacity — 142
$PASHQ,POW Query the battery power capacity — 142
$PASHS,PWR,OFF Turn the receiver power off — 146
$PASHS,RST Restore default parameter settings — 151
$PASHS,SAV Save parameters to memory N 151
Photogrammetry
/1PPS/Strobe
$PASHS,PHE Set photogrammetry edge Rising 137
$PASHQ,PHE Query photogrammetry parameters — 138
$PASHS,PPS Set period and offset of 1PPS signal 1, 0.0000, R 144
$PASHQ,PPS Query timing pulse parameters — 144
Velocity
Computation
$PASHS,DAP Set the Doppler averaging interval — 103
$PASHQ,DAP Query the Doppler averaging interval — 103
$PASHS,DYN Set the dynamic mode 8 110
$PASHS,SMV Set the speed filtering — 157
$PASHQ,SMV Query the speed filtering — 158
Session
Programming
$PASHS,EPG Set the kinematic epoch counter — 111
$PASHS,SES,PAR Set the session programming
parameters
— 154
$PASHS,SES,SET Set individual session parameters — 155
RTCM Remote
Station Status
$PASHQ,DFO Query the current status of RTCM
remote station
—104
Table 6.3. Receiver Commands (Continued)
Function Command Description Default Page
To Next Page
Loading...