Receiver Commands 95
Receiver Commands
Since they are required for all commands and responses, the <Enter> and <CR><LF> keystrokes are
omitted from the examples that follow.
Receiver
Configuration
$PASHS,AJM Enable/disable jam immunity Off 96
$PASHQ,AJM Query the jam immunity status — 96
$PASHQ,CLK Query clock status — 99
$PASHS,CTS Enable/disable RTS/CTS
handshaking protocol
Off 102
$PASHQ,CTS Query the current RTS/CTS setting — 102
$PASHS,DSY Set serial ports for daisy chain
communication
Off 105
$PASHQ,DUG Query UTC-GPS time difference — 109
$PASHQ,HLP Query the available receiver
commands
—120
$PASHS,LPS Set loop tracking parameters 10, 3, 1 130
$PASHQ,LPS Query loop tracking parameter setting — 131
$PASHS,LTZ Set local zone time 00hr 00 min 132
$PASHS,OOP Set the order of the output messages — 133
$PASHQ,OOP Query the order of the output
messages
—133
$PASHQ,PAR Query current receiver parameter
settings
—133
$PASHQ,PRT Query port baud rate 9600 145
$PASHQ,RID Query receiver identification
(Format 1)
—146
$PASHQ,RIO Query receiver identification
(Format 2)
—149
$PASHS,SMI Set the code measurement smoothing 100 sec
1° order
157
$PASHQ,SMI Query the code measurement
smoothing
—157
$PASHS,SNM Set the signal to noise mask 0
$PASHS,SPD Set baud rate of serial port — 158
Table 6.3. Receiver Commands (Continued)
Function Command Description Default Page
To Next Page
