ashtech DG16 - Page 114

94 DG14 and DG16 Board & Sensor Reference Manual
User-Defined
Transformation
$PASHS,UCT,UDD,APT Add a point for datum transformation — 164
$PASHS,UCT,UDD,CAL Calculate datum transformation
parameters
— 165
$PASHQ,UCT,UDD,CAL Query the datum transformation
parameters
— 165
$PASHS,UCT,UDD,EST Estimate a datum transformation — 166
$PASHS,UCT,UDH,APT Add a point for a local geoidal surface
transformation
— 166
$PASHS,UCT,UDH,CAL Calculate local geoidal surface
transformation parameters
— 165
$PASHQ,UCT,UDH,CAL Query the local geoidal surface
transformation parameters
— 165
$PASHS,UCT,UDH,EST Estimate a local geoidal surface
transformation
— 167
$PASHS,UCT,UG4,APT Add a point for a grid transformation — 168
$PASHS,UCT, UG4,CAL Calculate grid transformation
parameters
— 168
$PASHQ,UCT,UG4,CAL Query the grid transformation
parameters
— 168
$PASHS,UCT,UG4,EST Estimate the grid transformation — 169
$PASHS,UD4 Set user-defined datum to datum
parameters
WGS-84 169
$PASHS,UDD Set the user-defined datum — 170
$PASHQ,UDD Query the user-defined datum — 170
$PASHS,UDG Set user-defined datum to grid
transformation
— 173
Table 6.3. Receiver Commands (Continued)
Function Command Description Default Page