L
Language 17
Limit CLOSE 55
Limit OPEN 55
Local STOP 84
Low limit AIN 1 57
Low limit RWG 107
Low limit target value 58
Low limit Uspan 106
M
Mains quality 124
Maintenance interval 118, 120
Maintenance required 122, 123
Max. value at 100.0 % 42, 43, 44, 44
Maximum stroke 107
Minimum stroke 107
Modulating behaviour 60
Monitor 24 V DC cust. 96
Monitor 24 V DC ext. 96
Monitor heat. system 97
Motor running time 126
MPV function 68
N
No. mot. starts/h 108
Not ready REMOTE 122
Not ready REMOTE (Cfg) 28
Not referenced 128
O
Off time 1 51
Off time CLOSE 65
Off time OPEN 65
Off times 51
Oil leakage 126
Oil level 126
On time CLOSE 65
On time OPEN 65
On time warning 1 92
On time warning 2 92
Op. com. PID contr. 108
Op. time warning 123
Oper. mode Interlock 83
Oper. press. config. 127
Oper. time monitoring 93, 93
Oper. time opposite 68
Operat. pressure min 127
Operating time 120
Operational info 110, 110, 110
Operational info total 110
Operation behaviour 51
Operation behaviour 1 51
Operation mode 93, 107
Outer dead b. CLOSE 107
Outer dead b. OPEN 107
Outer dead band 54
Out of range 128
Out of specification 122
P
PCB failure 128
Perm.op. time, manual 93
Perm. run time 92
Permissible starts 92
Phase fault 124, 126
Phase monitoring 98
Pivot point 1 48
Posit. hyst. CLOSE 54
Posit. hyst. OPEN 54
Position 42, 42
Position activation 42
Position-time 114
Position transm. MWG 107
Position transm. potent. 106
Position transm. RWG 107
Potent. raw value /mV 106
Poti Out of Range 124
Pressure rise 126
Proc. var. activation 43
Process factor 43, 43
Process setpoint 108
Pump starts 127
PVST abort 123
PVST active 125
PVST behaviour 86
PVST fault 123
PVST monitoring 87
PVST operating time 87
PVST operation mode 86
PVST reminder 87
PVST reminder period 88
PVST required 123
PVST reversing time 87
PVST source 86
PVST stroke 87
R
Raw val. pos. CLOSED 106, 107
Raw val. pos. OPEN 106, 107
Rectifier fault 125
Reload languages 101
Replacement value 128
Reset characteristic 113
Reset factory settings 101
Reset operation. info 110
Revers. prevent. time 73
RTC voltage 123
Running dir. Interlock 83
RWG raw value /mA 107
138
Actuator controls
Parameter index ACV 01.2/ACVExC 01.2
To Next Page
Loading...
Need help?
General
