AUMA ACVExC 01.2 Series User Manual

H
Handwheel active 125
Heat.monitor.config. 126
Heater control unit 72
Heater monitor 97
Heating sys. mon. time 97
High limit AIN 1 57
High limit target value 58
Hydraulics fault 126
Hydraulics warning 127
Hysteresis 50
Hysteresis 1 50
I
I/O interface 125
IE 24 V AC 126
IE bus exception 127
IE config. pos. transm. 126
IE EEPROM 127
IE fieldbus 126
IE file access 127
IE Hall 1 calibration 127
IE Hall 5 calibration 127
IE I/O interface 127
IE LC 127
IE LC exception 127
IE logic 126
IE logic exception 127
IE MCM 126
IE mot. prot. monitor 126
IE MWG 127
IE MWG calibration 127
IE MWG end positions 127
IE MWG exception 127
IE output defective 126
IE parameter 127
IE parameter config. 126
IE phase monitoring 126
IE position transmitter 126
IE PSO 126
IE registration 127
IE remote interface 128
IE remote Prm Config 128
IE reserve backup 127
IE selector switch 126
IE startup FB 127
IE startup sub-assy 127
IE version 127
Import all parameters 102
Incorr. cmd REMOTE1 126
Incorr. cmd REMOTE2 126
Incorrect rotary direct. 124
Indicat. light 5 (right) 25
Indication light 1 (left) 25
Indication light 2 25
Indication light 3 25
Indication light 4 25
Inner dead b. CLOSE 107
Inner dead b. OPEN 107
Input AIN 1 29
Input AIN 2 29
Input of setpoint position 57
Interface 105
Interface status 105
Interlock 83, 125
Interlock by-pass 125
Interlock source 83
Internal error 124, 124, 126
Internal warning 123, 123, 127
Interval position-time 115
Invalid command 128
137
Actuator controls
ACV 01.2/ACVExC 01.2 Parameter index

AUMA ACVExC 01.2 Series Specifications

General

Brand	AUMA
Model	ACVExC 01.2 Series
Category	Controller
Language	English