Upgrading Communication Manager on Avaya S8700 Media Server from R1.x to R3.1
164 Upgrading, Migrating, and Converting Media Servers and Gateways
4. Perform one of the following actions:
● If the message says Sending only CR, close the dialog box.
● If the message says Sending both CR & LF, continue with step 5.
5. Type unset crlf and press Enter.
6. Type display and press Enter to verify that the settings changed.
The system displays the following message:
Sending only CR
7. Close the dialog box.
Note:
Note:
Erasing the MBR on the media server
To erase the master boot record (MBR):
1. Click Start > Run to open the Run dialog box.
2. Type telnet 192.11.13.6 and press Enter.
3. Log in as craft or dadmin.
4. Type sudo erase_mbr and press Enter to erase the MBR.
5. When the system displays the message, WARNING: Are you sure you want to erase the
master boot record? (y/n) [n], type y for yes.
6. Type quit to end the telnet session.
Inserting the Communication Manager CD-ROM into the media
server
Insert the CD-ROM that contains Communication Manager into the CD-ROM drive on the media
server. Close the tray.
Note:
Note: You can copy Communication Manager software from an http or tftp server onto
the media server. In this case, skip this step.
To Next Page
Loading...
Need help?
General
