Post-migration administration
Issue 2.1 June 2006 569
3. Type arp -d 192.11.13.6. Press Enter. This command produces one of the following
responses:
● The command line prompt displays when the cache is cleared.
● The message The specified entry was not found appears when the specified IP
address does not currently appear in the ARP cache.
4. To access the media server, type ping -t 192.11.13.6. Press Enter.
The -t causes the ping to repeat until you get a response. When you get a response, in
about 3 minutes, wait an additional 30 seconds before you go back to the Web interface.
5. To stop the ping, type ctrl c. Press Enter.
6. Close the MS-DOS window.
Logging in to the IPSI
To log in to the IPSI:
1. Use the PuTTY application to reaccess the server using the secure shell (SSH) protocol.
Note:
Note: Most commands have abbreviations. For more help while you are connected to
the IPSI, you can type help or ?.
2. Type ipsilogin. Press Enter. The abbreviated command is il.
Note:
Note: The craft login that you use on the IPSI has a different password than the craft
login used on the media servers.
3. Log in as craft.
Prompt = [IPADMIN]:
Setting the control interface
To set the control interface:
1. Type show control interface. Press Enter.
2. To see the current settings, type show port 1. Press Enter.
To Next Page
Loading...
Need help?
General
