Migration tasks
Issue 2.1 June 2006 425
Recording all busyouts
To record busyouts:
1. Type display errors. Press Enter.
2. Look for type 18 errors and record any trunks that are busied out. You can return these
trunks to the busyout state after the migration/upgrade.
Recording node names and IP addresses
To record node names and IP addresses:
1. Note the node names and the IP addresses that are assigned to the TN2302AP IP Media
Processor and the TN799C/DP C-LAN circuit packs. Ensure that these names and
addresses are the same after the migration.
Note:
Note: If the existing system has TN799C C-LAN circuit packs, you must replace these
circuit packs with TN799DP circuit packs.
2. To get the node names for the TN2302AP IP Media Processor and TN799C/DP C-LAN
circuit packs, type display ip-interfaces. Press Enter.
3. To get the IP addresses that match the node names, type list node-names. Press
Enter.
4. Record the information for use after the migration.
Migration tasks
You can reuse the translations from the current system when you migrate to an S8400 Media
Server.
Note:
Note: You must install the new Communication Manager license file on the media
server before you make the change. The SIPI serial number can be used for
licensing purposes.
Perform these tasks to change a processor port network to a port network (CMC).
To Next Page
Loading...
Need help?
General
