Post-migration administration
Issue 2.1 June 2006 407
Resetting the SIPI
To reset the SIPI:
1. Type reset. Press Enter
Answer Y to the warning.
Note:
Note: Resetting the SIPI terminates the administration session. If further administration
is required, start a new telnet session to the SIPI.
Note:
Note: Control network settings become effective when you exit the IPADMIN session.
Control settings include the IP address, the subnet mask, and the gateway.
2. Disconnect the Services laptop from the faceplate.
3. Check the LCD. Verify that it has an I P with a filled-in V that shows at the bottom. For more
information, see Figure 7: LED display that shows that the SIPI has a static IP address
.
Figure 7: LED display that shows that the SIPI has a static IP address
Note:
Note: Clear the ARP cache on the laptop before connecting to another SIPI. If the
cache is not cleared, the laptop appears to stop and does not connect to the next
IPSI. For more information, see Clearing the ARP cache on the laptop
computer on page 346.
4. Close the window.
CLK
ETR
S
E
R
V
fpdlled2 LAO 112905
To Next Page
Loading...
Need help?
General
