Avaya Vantage - Page 151

Parameter Type Default value Is set to
default on
reset
Description
• 1: To enable the logic. The PHNOL code
is appended to numbers that are shorter
than the shortest extension length.
PHNREMOVEARE
ACODE
String 0 Yes Specifies whether the area code must be
removed for local calls.
This parameter is obsolete. While it is still
supported for backward compatibility,
Avaya recommends you to use the newer
parameter,
DIALPLANLOCALCALLPREFIX.
DIALPLANLOCAL
CALLPREFIX
String 0 Yes Indicates whether the area code must be
removed for local calls. Assign one of the
following values:
• 0: To disable the removal of area code for
local calls.
• 1: To enable the removal of area code for
local calls.
Note:
Area code is configured using
DIALPLANAREACODE.
DIALPLANNATION
ALPHONENUMLE
NGTHLIST
String Null string Yes Specifies a list of national phone number
length (PHNLDLENGTH) values separated
by commas.
This parameter takes precedence over
PHNLDLENGTH.
Example:
SET
DIALPLANNATIONALPHONENUMLENGTHLI
ST 10,11
DIALPLANEXTEN
SIONLENGTHLIST
String Null string Yes Specifies a list of internal extension length
(PHNDPLENGTH) values separated by
commas.
This parameter takes precedence over
PHNDPLENGTH.
Example:
SET DIALPLANEXTENSIONLENGTHLIST
7,8
DIALPLANPBXPR
EFIX
String Null string Yes Specifies the PBX main prefix.
Table continues…
Avaya Breeze
™
CSDK parameters
May 2018 Installing and Administering Avaya Vantage
™
151
Comments on this document? infodev@avaya.com