48 User’s Manual—SNAP™ 700 Printer
Classification: Avery Dennison - Public
end of the platform.
a. For satin labels, use the lower position.
b. For coated labels, and short feed labels, elevate the outer end.
The label stop helps position the labels in the stack. The label stop is
magnetic. Follow these steps to adjust the position of the label stop.
2. Place a cut label on the stacker platform and slide it into the back corner.
3. Move the label stop to within 1/8 inch (3 mm) of the end of the label.
5.2.5 Static brush
The static brush has been mounted with a thumbscrew for easy adjustment to
help guide and control labels into the stacker. The brush should contact the
material as it exits the nip rollers. The static brush should be maintained in good
condition for the best stacking.
In general – a light pressure is sufficient to stack well, but long feeds will require
slightly more pressure.
Keep the static brush parallel to the nip roller mount bracket.
To Next Page
Loading...
