Avery Dennison SNAP 700 - Adjusting Voice Button Volume

User’s Manual—SNAP™ 700 Printer 43
Classification: Avery Dennison - Public
2. Press the Start / Stop button. The voice message will state, “Press Start
for Wide Setup Test Pattern”.
3. Press the Voice button.
4. The voice message will say, “Press Start for Wide Setup Test Pattern”.
5. Press the Start / Stop button. The voice message will say, “Ready to
Print Wide Setup Test Pattern. Returning to Print Mode.” The Data light
will turn on.
6. Press the Start / Stop button. The machine will begin printing Test
Pattern 2.
7. To stop printing the test labels, press the Start / Stop button. The Data
light will remain on. Make any necessary adjustments, and press Start /
Stop to resume printing the test labels.
8. Once satisfied with the test label you are running, press either the Start /
Stop or Voice button to stop the test run. The Data light will remain on.
9. Press and hold the Start / Stop and Voice buttons simultaneously to clear
the current batch of labels being printed.
10. The voice message will say, “Clearing Current Batch.” The Data light will
go out.
Test Pattern 3 and 4
The procedure for printing test pattern 3 and 4 is the same as described above.
4.5.2 Setting / Adjusting Voice Button Volume
The volume level of the voice messages on your SNAP 700 printer is set at Level
3 at the factory. To adjust volume:
NOTE: When you select volume setting, the menu will
begin with the current volume at which your machine is
set, Level 3.
1. Press and hold the Voice button longer than two seconds to activate the
Option Menu System.
2. The voice message will say, “Press Start for Test Pattern.”
3. Press the Voice button. The voice message will say, “Press Start for
Demos.”
4. Press the Voice button. The voice message will say, “Press Start to Set
Volume.”
5. Press the Start / Stop button. The voice message says, “Press Start for
Volume Level 3.”
To increase from volume level 3 to 5, follow these additional steps.
